![]() And, since the sliding valve is connected to the Play/Re-Roll linkage, the position of the Play/Re-Roll lever has an effect on the position of the sliding valve relative to the hole leading to the Cut-Out valve. That situation would accountįor the reduced volume of the music. This allows theĬut-out device to be 1/2 'on', 1/2 'off', which chokes the vacuum going to the stack. If that's the case, it (the leather) isn'tĬovering the hole (cut-out signal tube) 100%. The problem with the slider could be two-fold. Is located between the exhauster assembly and the stack. Lever arm It controls the operation of the Cut-Out device, which ![]() This prevents notes from playing as the music roll rewinds, or when the system is in the Re-Roll mode.Īs for the sliding valve that is connected to the transmission When the Cut-Off device is in the 'On' state, vacuum from the pump assembly is not allowed to flow into the note stack. NOTE: Aeolian employed two different methods of turning the Cut-Out device 'On' and 'Off' during the years that they made the modern Aeolian line of player pianos. Like maybe the Musette or the Duo/Art model. ![]() I'll bet that the player piano was made by Aeolian. With the leather nuts, so I could push to left without it stopping. Lever to far to left the piano would stop playing. Before I made adjustments, I noticed that if I pushed the play The piano is over twenty years old,Īnd she uses it for an exercise machine when it is cold outside, she I told her I would not cashĬheck until I figured out problem. I didĬall to find out how it was working, and she told me that sometimes Any way I charged her 50.00 and was on my way. Point I wished I had not come over to her house as she has another It would not re-roll and during playing stop and get weak. Seemed to re-roll fine and played OK, but every once in a while, Some on that round solid spindle with the white felt on top, it To make a long story short IĪdjusted speed control and others and I also lubricated, and I put Tried to adjust that little thin block that slides over that little I said I would take a look, that it was probably a hose off. Would not play as she was pumping it, but the air motor was turning. The other day with a player, Don't work on these often, although Modern Aeolian Service Manual List of all pages concerning problems with the modern Aeolian players Tips and Tricks - Modern Aeolian Problems
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |